7L Vacuum Oil Fluid Extractor Pump Changer Manual Fuel Pump Petrol Transfer
- List PriceUS$102.25piece
- Sale PriceUS$80.63piece
- ShippingFree Shipping
Working Pressure: 70-170PSI
Size: Approx. 70x25cm/ 27.56x9.84"
Tube diameter: Approx. 4mm, 6mm, 8mm, 10mm (0.16"/ 0.23"/ 0.31"/ 0.39")
Tube length: Approx. 93cm/ 36.61"
Simply pump operation for easily remove the liquid.
Manual pump with ergonomic grip to complete the fluid extraction independently.
Transparent hose allows visual inspection of fluid extraction.
It is easy to change the oil for your own car.
Ideal for removing: Engine oil, gear oil, coolant fluid, power steering fluid, brake fluid.
1 x Vacuum Fluid Extractor Pump
4 x Oil Tubes
1 x Manual
1. Don’t use this to extract or save petroleum or flammable liquids.
2. Don’t put the products and pipe in high temperature, snow and rain, direct sunlight place and so on.
3. Must drain fluid and clean after each use.
4. Brake tube is not included.
How to use:
1. The engine is in a flame out state, open the front cover of the car and pull the oil tape out.
2. Adjust the pumping pipe of the locking clip, so that the pipe end part extends into the machine room and the length of dipstick of equal length.
3. Insert the oil pipe into the oil scale hole and confirm the contact of the engine oil sump.
4. Shut off the oil discharge valve of the pumping unit.
5. Pressure vacuum suction handle 4-6 times, all of the waste oil can be pumped out.
6. Visual analysis of waste oil oil, oil extraction cost record.
7. Discharge the amount of oil to the waste oil concentration in the factory.
8. After extracting automobile waste oil, a little diesel can be used to clean the pump.